Meyer MDV Series Bedienerhandbuch PDF herunterladen (Seite 10)

INSTALLATION, OPERATING INSTRUCTION AND PARTS MANUAL

MDV SERIES



1. Spreaders with factory installed throttle controls

do not require installer hookup to the engine. The

actuator has been installed and tested at the

factory.

2. Remove the engine shroud and securely place it

on the ground.

3. The throttle actuator cable plugs into the in-cab

control panel after being routed from the cab of

the vehicle to the rear of the mounted spreader.

4. Select a suitable location in the cab of the vehicle

to mount the spreader control box. 



5. After the location of the control panel is deter-

mined, the cable must be routed to the front of

the spreader, securing as needed. Allow enough

cable for the control panel to be mounted in the

cab.

6. The routed cable must be clear of all moving or

hot parts on the spreader or the vehicle. Secure

the cable with the ties provided. Excess cable

must be coiled up and secured. Apply dielectric

grease to all connections for protection from the

salt spreading environment.

7. Mount the control panel (with the screws

supplied).

8. For a permanent cable mount, a mounting

bracket is supplied.

9. It is recommended that a 12 volt battery with 40

ampere hour rating be installed for winter use.

The battery hold downs furnished will accept any

2SM series battery.

10. Attach the positive battery cable (each end

should have a red rubber boot) to the positive

terminal on the solenoid and to the terminal of

the battery. Make sure these protective boots are

covering the positive terminal post on the battery

and on the solenoid.

11. Connect the negative battery terminal to the

engine mounting bolt for proper grounding. When

finished, make sure all wires are away from hot or

moving parts and replace engine shroud.

12. Plug cable from spreader into socket mounted on

truck.















(FACTORY INSTALLED ACTUATORS)













































3       NOVEMBER 

PAGE 10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 75 76

Kommentare zu diesen Handbüchern

Keine Kommentare

Meyer MDV Series Bedienerhandbuch Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Spreader Meyer MDV Series