Meyer MDV Series Bedienerhandbuch PDF herunterladen (Seite 19)

INSTALLATION, OPERATING INSTRUCTION AND PARTS MANUAL

MDV SERIES





1. Grease idler bearings on idler shaft take-up

assembly, outboard bearing on gearbox output

shaft, and spinner bearings every ten hours of

operation.

2. Grease input shaft bearing on gearbox every fifty

hours of operation.  Over greasing may

cause seal damage. The gearbox must be filled

to oil level plug with SAE 90 gear type lubricant.

Keep breather plug clean.

3. Drag chain slack on V-boxes should be checked

periodically and taken up if distance between

center line of front sprocket and point where chain

contacts lower flange on longitudinal is less than

eight (8) inches.  Over tightening

conveyor chain can cause serious drive train

problems. Above distance must not exceed

twenty (20) inches.

















4. If the spreader is equipped with a gasoline engine,

it should be maintained per engine manufacturer's

instruction. (Instructions and parts book is

enclosed.

5. V-belt/Chain tension must be maintained. The

V-belt/Chain can be adjusted by loosening motor

hold-down bolts and sliding motor as required.

To adjust chain tension on spinner shaft, loosen

the 8 bearing bolts on the rear vertical plates and

slide spinner shafts as required. Make sure the

spinner shaft is straight up and down before re

tightening.

 Overtightening may damage gearbox.

6. Oil drive chains before each use.

7. Spreader should be emptyed and cleaned after

each use. Material could freeze causing the unit

to not function correctly.

8. If chain becomes stuck or "frozen" to the floor to

the point where the drive system cannot pull the

load, never attempt to free chain using a pipe

wrench or any other tool on the output shaft. The

gearbox is designed to accept torque from input

shaft only. Trying to turn output shaft will strip the

gears, thus voiding the warranty.

9. To minimize problems and extend the life of the

drive system, the following is highly recommended

a. Before loading spreader, make sure the drag

chain is free (not stuck or "frozen" to the

floor). If the drag chain is stuck, this can

cause the drive system to burn up.



1. Grease all bearings, oil drag chain and roller

chains.

2. Raise spinner and remove spreader from truck.

3       NOVEMBER 

PAGE 19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 75 76

Kommentare zu diesen Handbüchern

Keine Kommentare

Meyer MDV Series Bedienerhandbuch Seite 19

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Spreader Meyer MDV Series